With QNH set, the altimeter reads altitude above mean sea level (on the ground, the airfield's elevation). With QFE set, it reads height above the airfield (zero on the ground). With 1013 hPa set, it reads pressure altitude, used as flight levels above the transition altitude.
The three settings
| Setting | Reads | On the ground | Used for |
|---|---|---|---|
| QNH | Altitude (above mean sea level) | The airfield's elevation | Below the transition altitude; terrain and airspace bases on charts |
| QFE | Height above the airfield | Zero | Circuits at some airfields |
| 1013 hPa (29.92 inHg) | Pressure altitude | The airfield's pressure altitude | Flight levels, above the transition altitude |
Converting between them
Near sea level, each hPa is about 27 ft (often rounded to 30):
- QFE from QNH: QFE ≈ QNH − elevation ÷ 27. At a 270 ft airfield with QNH 1015, QFE is about 1005.
- Pressure altitude from QNH: altitude + (1013 − QNH) × 27. At 2,500 ft on QNH 1003, that's about 2,770 ft, or FL 028 (just under FL 030).
Transition altitude and level
Climbing through the transition altitude, you set 1013 and fly flight levels; descending through the transition level, you set QNH again. The transition altitude is set by each country and often each area: 18,000 ft across the US, while in the UK and Europe it varies from place to place and is in the AIP.
The trap: high to low
Fly from high pressure to low pressure on the same QNH and the altimeter over-reads: you're lower than it says. Each hPa you haven't updated is about 27 ft, so keep the regional or airfield QNH current along the route.
Rules of thumb for understanding: use the published transition altitudes and ATC's instructions.