📏 PERFORMANCE

Density altitude explained, with a worked example

On a hot day, an aircraft at a sea-level airfield can perform as if it were thousands of feet higher. That's density altitude. Here's how to work it out from a METAR in three steps.

The short answer

Pressure altitude = elevation + (1013 − QNH) × about 27 ft. ISA temperature there = 15°C − 1.98°C per 1,000 ft. Density altitude ≈ pressure altitude + 120 ft for every °C the air is warmer than ISA.

Step 1: pressure altitude

Pressure altitude is what the altimeter would read on the airfield with 1013 hPa set. Near sea level, each hPa is about 27 ft (often rounded to 30), so a QNH below 1013 raises it, and one above lowers it.

Step 2: how far from ISA

The International Standard Atmosphere is 15°C at sea level, cooling about 1.98°C per 1,000 ft. Compare the actual temperature with ISA at your pressure altitude: the difference is the ISA deviation.

Step 3: density altitude

Add about 120 ft for every °C above ISA (or take it away below ISA).

A worked example

StepWorkingAnswer
Airfield elevation500 ft
Pressure altitude (QNH 1003)500 + (1013 − 1003) × 27770 ft
ISA temperature at 770 ft15 − 1.98 × 0.7713.5°C
ISA deviation (OAT 25°C)25 − 13.5+11.5°C
Density altitude770 + 120 × 11.5about 2,150 ft

On that day, a 500 ft airfield performs like one at over 2,000 ft: a longer take-off run and a slower climb. Humidity makes it a little worse still, which the rule of thumb leaves out.

Where it matters

Most POH performance charts take pressure altitude and temperature (and so account for density for you), while some, like the PA-28-140's, are read off density altitude. Either way, warm weather, high airfields and low pressure all lengthen your take-off and landing distances.

Altitude & Density, and PerformanceFree: pressure altitude, ISA deviation, density altitude (worked out exactly, with the 120 ft rule next to it) and QFE for any airfield from its METAR, and take-off and landing distances read from your aircraft's POH charts for those conditions.
Open Altitude & Density

Then compare your distances with the runway's: see declared distances. For the altimeter settings themselves, see QNH, QFE and flight levels.

Rules of thumb for understanding, not for planning: use your aircraft's POH for its performance.

Share this with a pilot friend or your flying club:
QUESTIONS

Common questions

How do you calculate pressure altitude? ▼
Elevation plus (1013 − QNH) × about 27 ft per hPa near sea level. Or set 1013 on the altimeter and read it.
What is the rule of thumb for density altitude? ▼
Pressure altitude plus about 120 ft for every °C the temperature is above ISA (15°C at sea level, cooling about 1.98°C per 1,000 ft).
Why does density altitude matter? ▼
The engine, propeller and wings perform according to the air's density, so a high density altitude means a longer take-off run and a slower climb.
KEEP READING

More on flying and pre-flight

Density altitude for any airfield.

Free. Import your logbook in a few minutes, or try the demo first.

Start Tracking - Free